P2P Control
# Turn P2P service on/off
If you bind multiple domain names in one account, those which open P2P services share traffic packets together. You can save on packet consumption by shutting down P2P services of one or several domain names in P2P Setting.
# Uploading Rules
This configuration allows you to define your own uploading logic with regards to the network condition. By default, uploading on cellular is enabled. Compatibility: web: 1.3+, android: 1.5+, iOS: 1.4+
# Activation Ratio
This config enables you to allocate an exact percentage of your audience to benefit from SwarmCloud peer-to-peer on a per-device basis. By starting with a small activation ratio, you will be able to test how our technology works on a small percentage of end-users. Then, you can increase it with time after checking the results.
# Signal Management
This config is used for configuration of signaling address. Signaling is used to exchange information between nodes to establish P2P connection. If the address is configured on this page, the one on the SDK side will be overridden.
# Stun Management
This config is used to configure the stun address. Stun is used for peers behind NAT to discover their public IP and port.